cad waterbottle

First I draw out the body of the water bottle using using line tools and dimension tools to make the measurement accurate. However, when I measure the water bottle I only use half of each measurement because i will later use the revolve tools to complete the body of the water bottle.

After I uses revolve tools of complete the shape I uses fillet tools to make the bottom of the water bottle curve.

Then I use shell tools to make the inside hollow and have the shell thickness of 2.8.

Next I repeated the process of sketching the lid part using line and dimension tools with half of the measurement and use the revolve tools to complete the lid of the water bottle.

Next I draw the layout of the holding part of the water bottle using sketch and dimension tools. After that I uses extrude tools to complete the part. Lastly, I use fillet tools to make the corner rounded.

To create a helix on the lid I uses plane in the middle of the lid and uses helix tools to create a curve helix line and uses sweep tool to make the part that is helix hollow.

Next I create a part where the helix will pass through and hold it tight. I create this part by sketch the part and extrude it.

Lastly, I have created the rubber by create a plane and split the rubber and the lid. I also uses the fillet function to to make it curve and look like a rubber.

Page updated

Report abuse