Running A Job

Pre-Work

• Design and File Preparation

• Safety Check

• Material Selection

• Laser Settings

Job Execution

1. Machine Setup

   • Place the material securely on the laser bed.

   • Use fixtures or weights if necessary to prevent movement.

2. Focus and Alignment

   • Focus of the laser

     • See Focus

   • Align the laser starting point with the design origin.

     • See Positioning

3. Test Cut

   • Perform a small test cut on scrap material or an unused corner.

   • Check the test cut for accuracy and adjust settings if needed.

     • See Test Cut

4. Run the Job

   • Start the laser cutting process.

   • Monitor the job for issues (e.g., flames, misalignment).

     • The laser will change colour to a brighter white when a through cut is achieved

Confirmation and Removal

1. Visual Inspection

   • Inspect the cut lines for completeness and accuracy.

   • Ensure all parts are cut through the material.

     • Perform a 'tap-test' to confirm that all pieces have been cut through.

       • If you have doubts, run the cut path again.

       • Some materials, like acrylic, will have a backing that makes inspection difficult. Best to rerun your cuts with high speed and low power and perform a visual inspection.

Cooling Period

1. • Allow the material to cool down before handling.

2. Removal from Bed

   • Carefully remove the cut parts from the laser bed.

   • Use tools if necessary to detach small or intricate pieces.

3. Final Inspection

   • Check for any remaining attachments or uncut areas.

   • Verify that all pieces meet the design specifications.

4. Clean Up

   • Clean the laser bed and surrounding area.

   • Dispose of or store excess material and scrap.