Download and Install

Downloading and installing OpenSpinMicroscopy is really easy. Download the files needed (links at the bottom of this page) and follow these steps:

1. Download the DSLM_control.jar file (Micro-manager 1.4.14 version)

2. Download the Config_EX_file.txt file

3. Copy those files into the mmplugin folder

4. Download the mmgr_dal_Arduino_SR.dll file and copy it into the main Micro-manager folder

5. Download the mmgr_dal_Arduino_GM.dll file and copy it into the main Micro-manager folder

6. Download the mmgr_dal_Arduino_FW.dll file and copy it into the main Micro-manager folder

If you have sample rotation:

1. Download the Arduino firmware and load it into your Arduino Board #1 (Adafruit or EasyStep version depending on your Arduino shield)

If you are using the Arduino Galvo system:

1. Download the Arduino firmware and load it into your Arduino Board #2.

If you are using the Arduino Filter wheel:

1. Download the Arduino firmware for Adafruit shield (ArduinoMicroManager_UIC_FILTER_WHEEL.ino) and load it into your Arduino Board #3.

2. Edit the Config_EX_file.txt file acording to your filter configuration.

After that, perform the hardware configuration using Micro-manager's "Hardware Configuration Wizard".

If you want to edit the OpenSpinPlugin:

1. Download the SourceCode.zip folder.

2. Extract the DSLM_Control folder.

3. Open the DSLM_Control project using Netbeans.

4. Link the needed Micro-manager folders to your project as described in the following link.