I used my carport as a jig to build the wings. After locating the wing attach fittings, I secured the spars together, then mounted them onto the the jig...then I was free to add the foam and glass. The spars were already built when I bought the fuselage...with the one exception that the front spar only had the full plywood web on one side (easily solved). The spars were built for the AS5048 templates. The length of the spars were longer than the standard KR2S and the chords were about 40% thicker than spec. I didn't want a large amount of taper (to maximize CG envelope) and I didn't need any more span so i decided not to include the "foam" spar extensions and decided to use the 33" template at the ends of the spars at 101". The combination of thicker chords and the 8" section should result in a max gross weight at least 50% greater than plans built spars with the AS5046 section...or a greater g loading...or a combination of the 2 and surprisingly only adds a few pounds to the airplane.
Note about CG envelope. The plans show a CG envelope for an aircraft with a MAC of 45.1 inches centered around the front spar precisely at the 1/4 chord. Which only applied to the KR1 that had an outboard rib of 36". Wing extentions shrink the envelope and front spar locations other than the 1/4 chord move the envelope relative to the inboard wing. You must consider what the MAC of your specific aircraft is.