mcjA3BodyconG

Introduction

This is an enhanced version of mcjA3BodyconF dress for Aiko3

can be found here: https://sites.google.com/site/mcasualsdazscripts3/mcja3bodyconf

BodyconF was a tight fit dress

BodyconG adds 20 morph channels named User0 to User19

and there's 18 morph injectors supplied as Poser .pz2 files

Installing

The installation package, a zip file, can be found at the bottom of this page

Please use the little down-arrr on the right side of the screen to download it in 1 piece

Unzip this file in a Daz Studio content folder

( a daz content folder typically contains a Runtime folder )

examples :

c:\program files\daz\studio\content

C:\Users\YOURBAME\Documents\DAZ 3D\Studio\My Library

Collar up-down

The collarBend morph is a bit experimental, it's in fact 4 morphs

the goal was to keep the dress down , instead of letting it be pulled up like rubber ( the default behavior )

also this morph system keeps the dress tightly fit, instead of inflating it as the breast and collar move up

the important point : the dress looks better if the collar up-down rotation is left at zero degrees

if you do raise a collar, the dress looks better if both collar bones move by the same amount

thigh Bend, Buttock bend

The morph that adjusts the dress when the legs bend is also tailored to keep a tight fit

if you see poke-through, you can solve it using the "lThigh" , "rThigh and sThigh bones

and/or the sit, sutBendLeft and sitBendRight morphs

credit : the dress rig is derived from rig of the CanGalSuits2A3 dress by BATLab

Sitting

A special "Sit" morph was added to the dress

it makes the dress look way better than the 2 leg-bend morphs discussed above

\

select the dress' hip bone

in the parameters tab

zero the sitbendLeft and sitbendRight morphs

increase the "sit" morph until you obtain this:

The 18 New Morphs Supplied With This Version of the Bodycon

If you unpacked the zip file correctly, the 18 morph injector files will be found in your Poser Content folder

under Poses/mcasual/mcjA3BodyconG

here they are

note that they are injected with a strength of 0

note that the morph controls are in the morphs section of the figure's Parameters Tab

Typically you would do this

adjust the length using the mcjLen morph

adjust the bell flaring using the mcjXZBell morph

add some waves using the mcjXZSin12 morph

License

You can use this models freely for personal or commercial use ( renders videos etc ... ).

You may not resell, distribute, sublicense or rent this models in any way.

you may credit this prop to mCasual/Jacques

THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED,

INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR

PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE

FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE,

ARISING FROM, OUT OF OR IN CONNECTION WITH