The geometry that Sketch Up uses is made up of edges and surfaces. So, in Sketch Up all geometry is created on edges and surfaces and each model uses these two building blocks. The basic surface consists of four edges and one surface. In the formation of the surface, at least three edges of the same level are required. The edges must form a loop. The surfaces and edges do not have a thickness and also the curved surfaces consist of smaller flat surfaces. Web Dialog interface allows you to enter the values ​​of the drawing you create, such as width or height. Since Ruby can communicate with JavaScript, data from the drawing can be sent also for Web Dialog. This Plugin draw face and counts the area. The width of the face can be given through the plugin interface. Plugin draws the defined surface and calculates its surface area.

Face Plugin

The starting point of the surface is 0.0.0. The program draws the surface and automatically calculates the range. Surfaces can be drawn to the desired amount. Plugins allow surfaces to be selected together or individually.The number and range of surfaces can be calculated together or individually. The surfaces of the models can be rotated together or individually. All the number of pieces, surfaces and edges in the models can be calculated. The program code can be edited so that also template properties can be downloaded to the Web dialog.

About plugins

These examples do not use volume models. All examples are surface models. Plugins allow surfaces to be selected together or individually. The number and range of surfaces can be calculated together or individually. The surfaces of the models can be rotated together or individually. Negative values ​​can also be given. All the number of pieces, surfaces and edges in the models can be calculated. The program code can be edited so that template properties can be downloaded to the Web dialog. The possibilities are almost limitless.