3 - PLAYBACKS

The Playbacks buttons are Override buttons . It means that values called from here takes (values doesn't matter) the high output priority.

Only Programmer can, momentarily, change the values used from a Playback button (PB).

To Clear the output from values coming from PB Ov buttons TOUCH & HOLD CLEAR button

There are two types of PB (Single or Switchable)

- Single (Soft Grey):

When Touched; Parameters will put (with predefined Time IN) on the output bus until other PB Button override it or Touch&Hold Clear will be pressed

- Switchable (Grey or Yellow):

Same as Single but you can switch off it to a predefined Level with a predefined Time OUT.

Recording, Editing, Deleting and Setting Play-Backs

- Recording:

Set programmer > Touch Rec Button > Touch PB to record > Clear Programmer

- Deleting:

Clear Programmer > Record Nothing on PB.

Be careful, because THIS ACTION HAS NOT CONFIRMATION

- Editing:

Eventually clear Programmer > TOUCH & HOLD Rec Button >

Touch PB that you want to LOAD on programmer > Modify programmer > Re-Record PB (or no)

Setting Play-Backs:

Touch&Hold a PB Button.

Write a name for your PB Button and choice if you want it as Single or Switchable

When Single only Name and Fade IN are available

Just choice Fade IN time in Seconds (no point is necessary, 0 sec by default (INSTANT))

Use + and - as a easy way to increment or reduce second by second

When Switchable all options are available

Choice Fade IN & Fade OUT (Of course can be different values)

Use + and - as a easy way to increment or reduce second by second

Eventually choice min value in % as value when you switch Off the PB instead of 0.

If Min Value is 0 All parameters will be out to previous values.

f.example

On a shutter parameter(ch25) where 100% is strobe, 10% is open and 0% is close.

-Rec a PB button with ch25 at full

-Make it as a Switchable > FadeIN 0sec > FadeOUT 0sec > Min Value at 10%

-Switch PB ON and OFF in order to activate or deactivate Strobo without close Shutter

TIP: In order to accurate value, touch Min Value and adjust it with the TrackPad where avalaible