3. Mod Podge Proxy

Mod Podge on Poker Chip

This is my first time working with Mod Podge, at the suggestion of several friends, so we'll see how it goes...

I decided to go all out on my first try, and will do at least five layers. Then wet sand it with #400,

followed by a polish with steel wool grade #0000.

I am using a wooden nickel instead of a poker chip on this one.

Add a thin layer of mod podge before adding the print.

Add the print and smooth it out, gloves would be recommended so there are no fingerprints.

Then, add a layer onto the print. It is white, but dries clear.

PS: don't do this like I did on paper...

(Remember to put the lid on the mod podge and wash the brush while waiting for it to dry)

It dries clear. I had to peel off the paper bits that got stuck.

Like I said, don't do this on paper, live and learn.

I moved project to the back of a plate. The mod podge is water soluble,

and washes off easily without leaving residue on the plate.

After two layers, I do the other side of the coin.

It will still be tacky at this point so use caution where you set it.

I alternate sides as they dry and keep adding layers.

Adding another layer: the more layers = more protection.

Add as many layers as you wish, letting it dry before adding additional layers.

It remains clear even with several layers (once dry).

One more thick layer for good measure :)

I started with the #400 sand paper. Don't forget to get it wet first!

Here you can see the rough edges on the coins.

After the edges are smoothed out with wet sand paper.

Next, a steel wool polish.

I then finished them off by using #0000 steel wool over them several times.

Personally, I didn't notice a big difference after the steel wool, so sand paper should be enough.

Here they are finished, allow at least two days before releasing so the tackiness is gone.

This proxy definitely takes some time, but looks really nice.

I hope you enjoyed!

BACK TO TOP

This tutorial has been brought to you by animjason