Title of Media
when i saw the coin eater example in the assignment , i liked the idea and after search on youtube i found that manual coin saving box , and i decided to make it automatic with two leds light indicators
i used tinkercad to build my circuit to make sure that everything working fine
i'll use card board for the body of the box
and will use cutter and glue to
Title of Media
Title of Media
i started by using 5v power source instead of 9 volt because i wanted the motor speed to be medium speed . and i'll put switch button to turn on and off the saving box with red led power indicator
then green led will turn on when i close the circuit with coin ( the other push button here instead of the coin )
and the same for the motor will work when i close the circuit when the coin touch the two aluminium paper pieces
i connected the led and the motor in parallel
*here i disabled the 1st push button that beside the power source to test the other push button
the 3 top pieces
after putting the aluminum paper
wood dowel sticked to rotate this piece
the saving box body
attaching wires to the aluminum paper
fixing the motor in the middle
connect all wires :D
assemble all pieces
Final Result
it was so many
1st the aluminium paper was so thin and sometimes it doesn't close the circuit easily
so it needed more tries
2nd how to connect the motor with the rotating part correctly
and i used wooden dowel and hot glue after alot of measurements
3rd connect all these wires correctly
and i did it after few tries
Title of Media
i learned how to build my circruit on tinkercad and test it , i learned how to connect more than one component in parallel and in series
the rc challenge
it was very challenging and fun time
and me and my team , ahmed and aya
we won it so easily
Title of Media
Title of Media