Embedded Files
Open weekdays from 10am | Closing: Mon–Thurs 4:30pm · Fri 4pm | Lunch: 12:30–1:30pm
Embossing is the process of creating a raised, three-dimensional design or pattern on a surface like paper, metal, leather, or fabric.
We can create custom dies from engraving into acrylic sheets using Laser Cutter. You will need to make sure you have had a laser cutting induction.
Laser Cutting Your Dies
Laser Cutting Your Dies
We recommend that you use acrylic sheets from our Material Stores at least 3mm thickness. OR 5mm thickness if you intend to engrave a high percentage of the overall size - this is because the acrylic plate will begin to bend as it becomes thinner and has the heat of the laser repeatedly going over the same area.
The software for the laser cutters in HPO will have a 'embossing' preset, or speak to us if you want to do a mixture of depths in one emboss.
You will need to mirror any text, graphic or images so that it is printed as you expect it look once its embossed. Otherwise it will be in reverse.
1.
Material & Thickness
1.
Material & Thickness
Cast acrylic 3-5mm (depending on % ratio of engrave to total size)
2.
Setting up your design
2.
Setting up your design
Make sure the acrylic plate is bigger than the final size of your paper, e.g If you want an A4 print, use A3 paper and an acrylic sheet which is slightly bigger than a4 - then cut paper down once you have embossed.
Otherwise the paper will be pressed around the acrylic
Page updated
Report abuse