4.1 Beaches

After completing this section, you should be able to say:

I can...

• recognize the various zones of a beach

• describe how the relationship between swash and backwash determines the composition of a beach

For most people, ...when they think of coastal areas they picture a beach, and the beach that they imagine is probably a typical sandy beach composed of quartz sand grains.  But beaches are comprised of whatever types of sediments are dominant in the local area.  For example, parts of Hawaii and Iceland are famous for their black sand beaches, made up of eroded basalt and other volcanic materials.  The beautiful tropical white sand beaches we see in travel ads are largely composed of the crushed calcium carbonate remains of coral skeletons (much of which has been chewed up and excreted by a fish before we happily run our toes through it!).  Other beaches may lack sand altogether and instead be dominated by small shells, or larger rocks or pebbles (Figure 13.1.1).

The shoreline is divided up into multiple zones (Figure 13.1.2).  The backshore is the region of the beach above the high tide line, which is only submerged under unusually high wave conditions, such as during storms.  The foreshore lies between the high tide and low tide lines; it is submerged during high tide and is exposed during low tide.  The nearshore extends from the low tide line to the depth where wave action is no longer influenced by the bottom, i.e. to where the depth exceeds the wave base.  Finally, the offshore zone represents the depths beyond the nearshore region.

Along the beach itself, the area above the high tide line is called the berm, which is usually dry and relatively flat.  The berm often ends with a berm crest or berm scarp, which is a steeper wall carved out by wave action that leads down to the foreshore.  The foreshore has a number of other names, including the beach face, the intertidal or littoral zone, and if the area is fairly flat, the low tide terrace.  Just off shore from the beach there are often longshore bars and longshore troughs running parallel to the beach.  The longshore bars are accumulations of sand that are deposited by wave action and longshore currents.  The decrease in depth above longshore bars is what often causes waves to start to break well before reaching the beach.

The sand or other particles that make up the beach are distributed by wave action.  The water that moves over a beach through incoming waves is called swash, and it also contains suspended sand grains that can get deposited on the beach.  Some of the swash percolates into the sand while the rest of the water washes back out as backwash as the wave recedes.  Backwash removes sand from the beach and returns it to the ocean.  Sand will therefore be deposited or eroded depending on which process is dominant.  If wave action is light, a lot of incoming water gets absorbed by the sand, so swash dominates.  Under heavier waves the beach becomes saturated with water, so less can be absorbed, and backwash is dominant.  This leads to seasonal cycles in beach structure; waves are heavier during the winter as a result of stormier conditions at sea, so backwash dominates and sand is removed from the beach and deposited offshore in longshore bars.  In the summer the waves are gentler, swash dominates, and the sand is transported from the longshore bar and deposited on the shore to create a wider, sandy beach (Figure 13.1.3).

Modified from, "Introduction to Oceanography" by Paul Webb.