Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Design is finalized
Begin Water jet cutting this week
Cables still need to be picked out
Software is starting to be analyzed
Accomplishments from Previous Week
Found places to cut with water jet cutter
Finalized design to be printed
Completed Ind. Component Analysis
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Have a better understanding of code - Trevor and Austin
Figure out where we are cutting the project at (Urey Hall or at SME) - Trevor and Austin
Pick out cabling - Kevin
Begin purchasing misc. equipment (bearings, collars, etc.) - Michael
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Address the current updates to our timeline regarding making one arm instead of two.
Go talk to Dr. Yip regarding force equations and software - Dr. Yip asked us to do so when software came around.
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Work on presentations
Continue digging into code
Risks and Areas of Concern
Cabling still has yet to be fully picked out (specific model, but general idea is done)
Lots of machining to create needed countersinks for bolts
Resources or Information Required but not Available
Still need to hear back from Steve Horvath over at the SME shop regarding water jet cutting since that would likely be much cheaper
Schedule
Describe upcoming milestone
Update Gantt chart.
Budget (list amount spent and amount remaining)
$4900 still remaining
Progress on Report and Webpage
Report has yet to be started
Webpage is up and operational