Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Designed and Manufacted a new nozzle for the Mammoth blower
Ran several experiments and acquired needed data
Accomplishments from Previous Week
Successfully designed and tested the new nozzle
Obtained data and checked the feasibility of our design
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Design several new nozzles with different exit angles
Compose an Experiment Protocol for the engineer in our Sponsor's site to guide him run experiments and obtain the data
Ship new nozzles to our Sponsor and have them tested those prototypes
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Meeting on 04/22/2020
Design several different nozzles to test which one works the best
Design a cap to cover the nozzles in Mammoth blowers that are not tested so it will result in a better wind speed
Need to care about the smoothness of the inner diameter
Have a list of what was needed in the test
Setup a test protocol to see what we needed in the test
Maybe make an adjustable part to save time and save material
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
N/A
Risks and Areas of Concern
The mass of the new nozzles will cause extra vibrations
Need to design different angles to see which one works the best
Need at least 6 nozzles to determine whether the design works, it could be a waste of time if not working
Resources or Information Required but not Available
N/A
Schedule
Describe upcoming milestone
Update Gantt chart.
Budget (list amount spent and amount remaining)
3D printing Filament: 210.09$
M4 Nut and Bolts 29.38$
Spent: $584.47
Remaining: $4415.53
Progress on Report and Webpage