Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Assembly of table are finished
Programming in progress
Testing the overall performance of the table
Accomplishments from Previous Week
The entire table assembling has been finished
The wiring and circuit design has been finished
The programming has started and in good process
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Assemble materials portion (brush stand, ink pots, wash trough)
Optimize the carriage design
Continue programming and testing the codes
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
NA
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
NA
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
NA
Risks and Areas of Concern
finding and coding a post processor
Smaller servo motors supplied by sponsor will supply sufficient torque
Small and large servo motors will be compatible
Resources or Information Required but not Available
We need to know if we will be able to use the same motors with the Linux machine system. They may require a minimum voltage that is higher than the motors used in the original drawing table.
Ink pot has not been set up due to lag time on delivery, however it is not essential for initial tests.
Schedule
Complete the entire table assembling
Started testing the table performance
Update Gantt chart.
Budget (list amount spent and amount remaining)
$692.62 = duplicate table w/o motors, gears, and timing belts
$384 = motor kit
(3) 425 oz-in stepping motors, NEMA 23
(3) KL-4030 Drivers (3.0Amp 24-40 Volts, 1-1/64 microstepping)
(1) 36VDC/ 9.7A Power Supply 110VAC/220VAC
(1)C10 Breakout board
(1) 5V power supply
Progress on Report and Webpage
Weekly Progress Report
Second Draft Report
Second Draft Webpage