Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Programming in progress
In testing stages
Holding up paper clamp
Electronic Cases
Accomplishments from Previous Week
The programming has started and in good process
Paper clamp installed
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Paper clamp (Kent)
Electronic Case (Jay)
Wash sectiong (Greg)
Continue programming and testing the codes (Eric & Jon)
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
NA
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
NA
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
NA
Risks and Areas of Concern
finding and coding a post processor
Resources or Information Required but not Available
NA
Schedule
Fabricate paper clamp holder when changing paper
Testing the table performance
Budget (list amount spent and amount remaining)
$692.62 = duplicate table w/o motors, gears, and timing belts
$384 = motor kit
(3) 425 oz-in stepping motors, NEMA 23
(3) KL-4030 Drivers (3.0Amp 24-40 Volts, 1-1/64 microstepping)
(1) 36VDC/ 9.7A Power Supply 110VAC/220VAC
(1)C10 Breakout board
(1) 5V power supply
Progress on Report and Webpage
Weekly Progress Report
On process of finalizing poster and final report