Embedded Files
2W or 5W Full Duplex Wireless Transceiver Video Data Link
2W or 5W Full Duplex Wireless Transceiver Video Data Link
This was created for wireless video and data transmission via a two-way wireless data link.
This OFDM radio device operates in the 800MHz or 1.4GHz bands, with frequency hopping technology (FHSS) to ensure better signal communication stability.
TDD OFDM full-duplex wireless transceiver for video and data links
Up to 30Mbps Iperf Throughput @20MHz channel
Supports both point-to-point and point-to-multipoint networks
Web browser interface
2 Ethernet and 1 TTL uart data link
OFDM modulation with TDD
Supports the 806-826MHz band or the 1428-1448MHz band
FHSS is supported within each band.
Bandwidths of 1.4/3/5/10/20MHz
Maximum throughput of 30Mbps@20MHz
Radiofrequency transmission 2W or 5W maximum PA power amplifier
QPSK, 16QAM, 64QAM, self-adaption Constellation
108dBm Sensitivity (1Mbps)
IP data transmission is supported (2 Ethernet ports)
Serial data transmission is supported (1 channel, TTL)
1-7km (ground-to-ground), 30-100km (UAV-to-ground, optional distance grade)
Management web interface
Encryption with AES128
Control of the uplink and downlink streams
Point-to-Point, Point-to-Multipoint, Relay, and Mesh networking modes are available (specify)
Movement Speed: Supports up to 120km/h.
Lightweight and small in size
Housing made of tough aluminum alloy
Input power: 12-16V(2W), 24-25V (5W)
12W (RF Power 2W), 18W power consumption (RF Power 5W)
The dimensions are 102*52*21.5mm.
120g in weight
Input and Output
1: ANT2, Rx Antenna port, SMA female
2: ANT1, Tx/Rx Antenna port, SMA female
3: Power in, VDD: red cable GND: black cable
4: Data uart, 3PIN PH1.25mm lockable connector
5: Link LED, Green, light on wireless linked(only for Access Node)
6: USB device, Micro USB, for software upgrading
7: Power LED, Red, light on normal powered
8: Ethernet 1 LED, Green, blinks on data transmission
9: Ethernet 1, 4PIN PH1.25mm lockable connector
10:Ethernet 2 LED, Green, blinks on data transmission
11: Ethernet 2, 4PIN PH1.25mm connector
This model can operate in two modes: access node and central node.
It is manageable via a web interface.
It supports up to 16 Access Nodes connected to a Central Node.
The Nodes are all connected to the same wireless LAN and share the entire transmission bandwidth (maximum 30Mbps@20MHz throughput).
Data from the Central Node to the Access Node is referred to as downlink, and data from the Access Node to the Central Node is referred to as uplink.
The web UI allows you to control the ratio of uplink and downlink streams.
When using this model for point-to-point transmission, the uplink and downlink share the entire transmission bandwidth (up to 30Mbps@20MHz throughput).
It is compatible with the following networking modes: point-to-point, point-to-multipoint, relay, and mesh (specify mesh version when order).
Page updated
Google Sites
Report abuse