Full duplex wideband wireless IP data links on the move.
Up to 30Mbps Iperf Throughput @20MHz channel.
Networking mode: Point-to-Point, Point-to-Multipoint, Relay, and Mesh(specify).
Interface through a web browser or control uart.
2 Ethernet and 3 channel RS232 data links.
Audio in/out is supported by the inside audio codec.
Long-distance wireless transceiver with 10W RF power.
806~826HMz band or 1428~1448MHz band, 3/5/10/20MHz bandwidths.
Dimensions: 124*67.8*28.5mm, Weight: 252g
Low latency H.265/H.264 video encoder module, full HD resolution, maximum 1080P60 encoding.
Audio codec with audio input and output.
HDMI/AV video input, Ethernet RTSP/TS stream output, TCP/UDP protocol.
Web UI or uart for management.
Optional: HDMI+AV input and encoding at the same time.
When paired with our SHD5 decoder module, the H.265 video latency is about 250ms.
When paired with our SHD4 decoder module and in the lowest H.264 mode, the video latency is about 50ms to 130ms.
Integrated with RCB as COFDM transmitter module, supporting third-party wireless link too.
10W RF Linear Power Amplifier for DLB/DLM module.
Frequency band: 1420MHz-1460MHz(PA1410) , 800MHz-830MHz(PA810).
RF in: IPEX connector, 25±2dBm(Sihid DLB/DLM module RF out).
TX Gain: 18dB, RF out power 40~42dbm, SMA female connector.
Power input: DC24V~30V.
Power consumption: <28W average.
Dimensions: 65*62*13.5mm, not including the connector out of the metal housing.
Weight: 98g.
Full duplex wireless transceiver module for video and data Link
Up to 30Mbps Iperf Throughput @20MHz channel.
RF power out 25±2dBm
Working Frequency: 806~826HMz, 1428~1448MHz, 2402~2482MHz
2 Ethernet and 3 TTL uart data link
Audio input and output with codec
Interface through a web browser or control uart.
Transmit distance: 500~2000 meter(ground-to-ground), 5~17km(UAV-to-ground)
1W/2.5W HD video COFDM wireless downlink transmitter with HDMI/SDI/AV video input.
Frequency Bands: 200~860MHz(Specify central working frequency).
Bandwidth configurable from 1MHz to 8MHz, step by 1KHz
COFDM modulation and H.264/H.265 video compression.
Full HD resolution, maximum 1080p/i @60fps, or 3840*2160P@30fps(optional).
Supports two-channel videos at the same time(optional).
Great security by AES encryption.
Modular design and high integration.
Stable signal transfer in NLOS and high-speed motion.
Adjustable working frequency, bandwidth, bit stream rates, RF power, etc.
Comprehensive setup with our Config Panel or PC or other devices via Control UART.
Full duplex wireless transceiver module for video and data Link
Up to 30Mbps Iperf Throughput @20MHz channel.
RF power out 25±2dBm
Working Frequency: 806~826HMz, 1428~1448MHz, 2402~2482MHz
2 Ethernet and 3 TTL uart data link
Audio input and output with codec
Interface through a web browser or control uart.
Transmit distance: 500~2000 meter(ground-to-ground), 5~17km(UAV-to-ground)
Our wireless video transmitters have these types of video input interfaces: HDMI 1080P and 4K HDMI, CVBS composite, SDI, AHD, IP Ethernet, BNC, or tell us what type do you need, our engineer will modify to meet your demand.
Our transmission distance can be adjusted by adding power amplifiers. At present, the main ones are 15 km, 30 km, 50 km, 80 km, 100 km , and 150 km, which depend on the needs of customers.
Of course, the transmission distances listed above are all within LOS the line-of-sight range. If there are obstacles between the transmitter and the receiver, NLOS (the non-line-of-sight), the transmission distance is greatly reduced, only 1 km or 2 km, depending on the number of intermediate obstacles and the local wireless environment.
One-way means, We can only transmit and download video or data from the wireless video transmitter to the receiver in one direction, and we cannot upload video or data from the receiver to the transmitter. This type is also called simplex.
Two-way means that, not only we can download video or data from our wireless transmitter to the receiver, but also we can upload the video or data from the receiver to the transmitter. This is very suitable for operating drones. You can not only see the real-time video transmitted from the drone, but also upload the command to control the drone or the command to control the PTZ camera to adjust the angle to the transmitter. This can operate simultaneously. This type also named half-dulpex or full-duplex.
Please check the details at the below link. https://ivcan.com/request-a-quote-of-wireless-video-transmission/#simplex
Most Wireless video transmitters now support AES128 or AES256 bit encryption and decryption, depending on which model you choose. Please contact us to verify.
The frequencies of both the wireless video transmitter and the wireless video receiver can be modified. Users need to purchase additional parameter configuration boards. However, considering that the corresponding power amplifier and antenna are already fixed within a certain range when the goods are sent out. If the user adjusts the frequency of the transmitter, the corresponding power amplifier, transmitter antenna and receiver antenna should also be modified to the same frequency, and these users need to be prepared. If not, it will cause the frequency of the wireless video transmitter to be different from the frequency of the antenna, making reception difficult. So please be sure to inform the correct frequency you need before placing an order.
If it is for security or confidentiality, you can use the encryption and decryption functions of the transmitter and receiver, which can ensure that your video transmission is private. .
Yes, all our product parameters can be customized according to customer's needs. If you have a special request, please let us know via the link below.
https://ivcan.com/request-a-quote-of-wireless-video-transmission/