DRAWINGS

Basic Part Drawings

These collection of Drawings are Basic with simple dimensioning, Center lines where holes are located and section views.

Part 0001

C -1001

C-1002

C1003

CAD111-0004

A-1005

A-1006

A-1007

A-1008

Moderate Parts

These section of drawings are more complex, and more detailed With (GD&T), Unit conversion, section views.

CAD-0002

CAD-002 started with the three basic Views Top, Front and Right planes then dimensioned accordingly, with center lines through the hole and lastly with geometric tolerancing on the front and right planes.

CAD-0003

CAD111-0003 Starts with the three basic views and and Dimensioned Accordingly. The Drawing has center lines, section View and two types of measurements inches and millimeters.

A-1004

A-1004 started with three basic views and dimensioned Accordingly. This drawing contains section views and center lines.

Assembly Drawings

These set of Assembly drawings contain The three views of the assembly and both the explosion view and collapsed view and also a bill of material or (BOM) and lastly ballooning.

A1000

The Arbor Press has the three basic views of the assembly in the bottom left corner. The Explosion View, takes up most of the upper right corner with great detailed with labeled individual parts with Ballooning ,which corresponds with the bill of material that's located on the upper right hand corner, Which contains 14 individual parts.

V-1000

V-1000 or the Machinists vice starts with the three views on the bottom right and then the explosion View on the top Left with Ballooning, that goes with the bill of material that's located on the bottom left. And the revision table on the top right.

PIPE VICE

The Pipe vice is my personnel project. I've chosen this project because I wanted a challenge to design complicated parts with detail.

The Pipe vice drawing is no different from the others, it contain the three basic views top, Front and right planes in the bottom right. Left of the views is Bill of material with the part numbers. Then you have the Explosion View of all the parts and labeled with ballooning that corresponds to the Bill of material.

Below Are the Models that associate with the pipe vice

ADJUSTMENT SCREW

HANDLE

LOWER JAW

UPPER JAW

Pad lock

Page updated

Google Sites

Report abuse