Zwave devices
After adding a zwave device, may have to restart pi after a power up
Z-Stick Gen 5 controller
Removing devices via its button (Example).
Remove the Z-Stick from your PC USB port (disconnect)
Press and hold the Z-Stick Gen5 button until its LED should blinks yellow rapidly, then release its button.
Now go to your Switch or Z-Wave device, and tap its button quickly (most devices use a single tap, but some Z-Wave devices may have special operations to unpair, please refer to your Z-Wave devices manual to unpair it from the Z-Stick).
If successful, you'll notice that the Z-Stick Gen5s LED will become solid blue for 2 seconds to indicate a successful unpair, then it will return to blinking yellow rapidly to allow you to continue removing other devices.
You can continue to remove devices while it is blinking yellow rapidly (follow steps 3-4 with each device you want to remove then continue to step 6 when you are done)
Once you are done, tap the Z-Sticks button once and the LED should stop blinking.
Adding devices via its button (Example).
Remove the Z-Stick from your PC USB port (disconnect)
Tap the Z-Stick Gen5 button, and its LED should blink blue
Now go to your Switch or Z-Wave device, and tap its button quickly (most devices use a single tap, but some Z-Wave devices may have special operations to pair, please refer to your Z-Wave device's manual to pair it to Z-Stick).
If successful, you'll notice that the Z-Stick Gen5s LED will blink rapidly, and if the pairing was a complete success, the LED on Z-Stick Gen5s blue LED will become solid for 2 seconds (if it failed, then a red LED will appear for 2 seconds instead) then continue to blink blue slowly
You can continue to add new devices while it is blinking blue slowly (follow steps 3-4 with each device you want to add one at a time)
Once you are done, tap the Z-Sticks button once and the LED should stop blinking.
Zooz Zen27 dimmers
1. ADD DEVICE to your hub Initiate inclusion (pairing) in the app (or web interface).Â
2. Finalize inclusion at the switch. TAP 3 TIMES QUICKLY The LED indicator will blink to signal communication and remain on for 2 seconds to confirm inclusion.
1. Initiate EXCLUSION and tap the lower paddle 3 times quickly.
Leviton Decora