Advanced ceramics

Publications and Presentations

Featured article: Chevalier J , Liens A, Reveron H, Zhang F, Reynaud P, Douillard T, Preiss L, Sergo V, Lughi V, Swain M, Courtois N, "Fourty years after the promise of «ceramic steel?»: zirconia-based composites with a metal-like mechanical behavior", Journal of the American Ceramic Society 103 (3), 1482-1513 (2020)

A Liens, H Reveron, T Douillard, N Blanchard, V Lughi, V Sergo, R Laquai, et al. “Phase transformation induces plasticity with negligible damage in ceria-stabilized zirconia-based ceramics”, Acta Materialia 183, 261-273 (2020)

H Reveron, M Fornabaio, P Palmero, T Fürderer, E Adolfsson, V Lughi, Alois Bonifacio, Valter Sergo, Laura Montanaro, Jérôme Chevalier, "Toward long lasting zirconia-based composites for dental implants: Transformation induced plasticity and its consequence on ceramic reliability", Acta biomaterialia 48, 423-432 (2017)

Lughi V and Sergo V, “Low temperature degradation -aging- of zirconia: A critical review of the relevant aspects in dentistry”, Dental Materials 26 (8), 807 (2010)

Lughi V and Clarke DR, “Temperature Dependence of the Yttria-Stabilized Zirconia Raman Spectrum”, Journal of Applied Physics 101, 053524 (2007)

Lughi V and Clarke DR, “Low Temperature Transformation Kinetics of Electron-Beam Deposited 5 wt% Yttria-Stabilized Zirconia”, Acta Materialia 55, 2049 (2007)

Faulhaber S, Kraemer S, Lughi V, Clarke DR, Levi CG, Hutchinson JW, Evans AG, “Mechanisms of Delamination in Thermal Barrier Systems Subject to Calcium-Magnesium-Alumino-Silicate (CMAS) Penetration”, 31st international conference on advanced ceramics and composites, 2007, Daytona Beach FL

Lughi V and Clarke DR, “Defect and Stress Characterization of AlN Films By Raman Spectroscopy”, Applied Physics Letters 89, 241911 (2006)

Callaghan LA, Lughi V, Mac Donald NC, Clarke DR, “Beam-Supported AlN Thin Film Bulk Acoustic Resonators”, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control 53 [5] 1001-1007 (2006)

Gentleman MM, Lughi V, Nychka JA, Clarke DR, “Noncontact methods for measuring thermal barrier coating temperatures”, International Journal of Applied Ceramic Technology 3 (2): 105-112 (2006)

Lughi V and Clarke DR, “High Temperature Aging of YSZ Coatings and Subsequent Transformation at Room Temperature”, Surface Coatings and Technology 200 [5-6] 1287-1291 (2005)

Lughi V and Clarke DR, “Transformation of 8YSZ EB-PVD Yttria-Stabilized Zirconia Thermal Barrier Coatings”, Journal of the American Ceramic Society 88 [9] 2552-2558 (2005)

Lughi V and Clarke DR, “High Temperature Aging of YSZ Coatings and Subsequent Transformation at Room Temperature”, presented to the International Conference on Metallurgical Coatings and Thin Films, San Diego, CA, May 2005

Lughi V, Tolpygo VK, Clarke DR, “Microstructural aspects of the sintering of thermal barrier coatings”, Materials Science & Engineering A-Structural Materials Properties Microstructure & Processing A368 [1-2] 212-21 (2004)

Lughi V, Colombi Ciacchi L, Kong CM, Lannutti JJ, Sergo V, “Piezo-spectroscopic determination of residual stresses in an Al/sub 2/O/sub 3//NiAl FGM”, Key Engineering Materials 175-176, 183-8 (2000)

Colombi Ciacchi L, Gregori G, Lughi V, Rossi A, Sergo V, “Piezo-Spectroscopy: a Materials Science Perspective”, Recent Research Developments in Applied Spectroscopy 2, 243-272 (1999)

Lughi V, Sergo V, Nagel A, “Residual stress and secondary phase analysis of Si3N4 cutting tools”, presented to Engineering Ceramics 99, Smolenice (Slovakia) May 1999

Sergo V, Lughi V, Pezzotti G, Lucchini E, Meriani S, Muraki N, Katagiri G, Lo Casto S, Nishida T, “The effect of wear on the tetragonal-to-monoclinic transformation and the residual stress distribution in zirconia-toughened alumina cutting tools”, Wear 214, [2], 264-70 (1998)