Part 46 new miner Checklist

PART 46—TRAINING AND RETRAINING OF MINERS ENGAGED IN SHELL DREDGING OR EMPLOYED AT SAND, GRAVEL, SURFACE STONE, SURFACE CLAY, COLLOIDAL PHOSPHATE, OR SURFACE LIMESTONE MINES.

§ 46.5 New miner training.

(a) Except as provided in paragraphs (f) and (g) of this section, you must provide each new miner with no less than 24 hours of training as prescribed by paragraphs (b), (c), and (d). Miners who have not yet received the full 24 hours of new miner training must work where an experienced miner can ob- serve that the new miner is performing his or her work in a safe and healthful manner.

(b) Before a new miner begins work at the mine—

You must provide the miner with no less than 4 hours of training in the following subjects, which must also address site-specific hazards:

(1) An introduction to the work environment, including a visit and tour of the mine, or portions of the mine that are representative of the entire mine (walkaround training). The method of mining or operation utilized must be explained and observed;

(2) Instruction on the recognition and avoidance of electrical hazards and other hazards present at the mine, such as traffic patterns and control, mobile equipment (e.g., haul trucks and front-end loaders), and loose or unstable ground conditions;

(3) A review of the emergency medical procedures, es- cape and emergency evacuation plans, in effect at the mine, and instruction on the firewarning signals and firefighting procedures;

(4) Instruction on the health and safety aspects of the tasks to be assigned, including the safe work procedures of such tasks, the mandatory health and safety standards pertinent to such tasks, information about the physical and health hazards of chemicals in the miner’s work area, the protective measures a miner can take against these hazards, and the contents of the mine’s HazCom program;

(5) Instruction on the statutory rights of miners and their representatives under the Act;

(6) A review and description of the line of authority of supervisors and miners’ representatives and the responsibilities of such supervisors and miners’ representatives; and

(7) An introduction to your rules and procedures for reporting hazards.

(c) No later than 60 calendar days after a new miner begins work at the mine—

You must provide the miner with training in the following subject:

(1) Instruction and demonstration on the use, care, and maintenance of self-rescue and respiratory de- vices, if used at the mine; and

(2) A review of first aid methods.

(d) No later than 90 calendar days after a new miner begins work at the mine—

You must provide the miner with the balance, if any, of the 24 hours of training on any other subjects that promote occupational health and safety for miners at the mine.

(e) Practice under the close observation of a competent person may be used to fulfill the requirement for training on the health and safety aspects of an assigned task in paragraph (b)(4) of this section, if hazard recognition training specific to the assigned task is given before the miner performs the task.

(f) A new miner who has less than 12 cumulative months of surface mining or equivalent experience and has completed new miner training under this section or under § 48.25 of this title within 36 months before beginning work at the mine does not have to re- peat new miner training. However, you must provide the miner with training specified in paragraph (b) of this section before the miner begins work at the mine.

(g) A new miner training course completed under § 48.5 or § 48.25 of this title may be used to satisfy the requirements of paragraphs (a), (b), and (c) of this section, if the course was completed by the miner within 36 months before beginning work at the mine; and the course is relevant to the subjects specified in paragraphs (b) and (c) of this section.

[64 FR 53130, Sept. 30, 1999, as amended at 67 FR 42382, June 21, 2002]