Embedded Files
putting the printer together
Calibration Cube
Calibration Cube
top and side 1 and 2
bottom and side 4
side 2 and 3
side 4
top side 3 and 4
top and side 1 and 3
bottom side 3 and 4
roller chain
roller chain
finished
finished
finished
printing
class project desk topper
class project desk topper
for this print we were instructed to make a topper that would fit a pole attached to the desk
instructions
Must be designed in SolidWork
Prepared in a slicer for additive manufacturing
3D printed in PLA filament
The object cannot take up more space than as 80mm sphere.
Unlike the previous year, you must create a ring to fit over the vertical monitor support. Make sure to use a caliper to measure. Don’t rely on a peer’s measurements. The object will then somehow be attached to the side of the ring so that the other student from the other class can also display their project on the other side of the support.
Test prints for the ring support are required before full prints (this has to be displayed on the ePort)
test printed of ring to make sure the print would fit
topper printing
the print in hand
the final print and attached to pole
the base
the topper
together in solidworks
in the slicer
Page updated
Google Sites
Report abuse