Struts

Strut Segment Count

This is the number of segments KaroroCAD will build the struts out of. 

PLEASE NOTE: Depending on the profile chosen the actual number of segments created could be less. This is especially true with profiles that are very straight towards the TE, less segments may be needed to follow the profile.

First Seam Clearance

This control allows the first seam in the front of the struts to be pulled away from the canopy for clearance.

Strut LE Size %

Controls the leading edge end diameter of the strut as a % of the leading edge at that position.

Strut TE Size %

Controls the trailing edge end diameter of the strut as a % of the leading edge at that position.

Strut Selection

This table selects which canopy seams will have struts, based on one half of the kite. Left most figure is the center seam, moving towards the wingtip as you go right. A 1 indicates a strut is present at that seam and 0 is no strut present. Figures beyond the number of seams in the kite are ignored. 

Strut Offset from TE mm

The distance in mm the strut and start sewing point is located away from the TE - gives clearance for TE finishing details if required.