KaroroCAD comes with 5 options for bridle alignments - choose one.
Very similar to the STRUT SELECTION TABLE - starting from the middle of the kite a ‘1’ represents a bridle attachment at that intersegment seam on the LE, and a ‘0’ shows no connection. Please make sure the number of ‘1’s at least matches the style of bridle chosen.
The distance, (as a fraction of the overall height of the kite) the front line connection to the bridle is under the kite.
The length of the control lines this kite is expected to be flown on - this affects the bridle balance calculations.
The kite angle of attack the bridle design will be based on
A set of controls to adjust the relative tensions in each section of the bridle.
The distance in MM the rear line attachment point is placed forward of the end corner of the wing tip.
A separate control for setting the relative length of the rear line bridle