1) Swing the G5RV to hang over the North parking lot.
2) Install a mast in the North East corner of the SIGNALS lot to support one end of the G5RV.
3) Terminate the coax that exits the building on the North side at the tower.Â
4) Pull RG-8 from the cable entry to the shack, 2 runs.
5) Ballast the LPDA tripod with a steel grate.
6) Finish the installation of the 4' beacon dish
7) Install the 10 GHz (3cm) FM beacon on the 4' dish.
8) Install the Ku Band LNA for reverse beacon on the 4' dish
9) Install a Raspberry Pi to host OpenWebRX for the reverse beacon.
10) Terminate the Heliax feedline,
11) Install the Heliax feedline and connect to the LPDA.
12) Install a sheath conduit to neaten up all the cables exiting the building on the east side of K4MIE. Include drip loops.
13) Install yard arm with pulleys on the tower.
14) Construct a 2m/70cm vertical collinear antenna.
15) Hang the collinear on the yard arm.
16) Construct an AMSAT capable antenna.
17) Install AMSAT antenna on the roof.
18) Install a remote antenna switch for VHF and above to switch between LPDA and Satellite ops.
19) Install a 5.8 GHz AREDN Mesh node feedhorn on the 4' dish.