Arduino

ARDUINO IS AN OPEN-SOURCE PHYSICAL COMPUTING PLATFORM DESIGNED TO MAKE EXPERIMENTING WITH ELECTRONICS MORE FUN AND INTUITIVE. ARDUINO HAS ITS OWN UNIQUE, SIMPLIFIED PROGRAMMING LANGUAGE, A VAST SUPPORT NETWORK, AND THOUSANDS OF POTENTIAL USES, MAKING IT THE PERFECT PLATFORM FOR BOTH BEGINNER AND ADVANCED DIY ENTHUSIASTS.

Circuit 1 - Manipulate the code so that the blink can barely be seen. Post an image of the code that was changed along with the video of the working circuit. (Bonus - get the blink to gradually increase over time)

This is the normal speed at one sec, whit delay of 1000.

Once the delay rate is down to 20 on the circuit. the light will start blinking much faster than usual.

Circuit 2 - Write an explanation of how the potentiometer work.

So what a potentiometer does is limit the amount of power that is flowing into the device. It does this with three prongs that connect to three different components: the track, which is the distance the electricity has to travel within the knob, and limits how much energy goes to the device. The wiper manually controls how much power goes through the track. The outer pins are connected to the ground and provide power to the device that you're using.

Circuit 3

Circuit 3 is to make a RGB light move smoothly throughout different colors

Circuit 4

Circuit-5

Circuit five is to make buttons activate a light and if you press one button and turn it on if you press two buttons it turns it off

Circuit 6

Auto-tune on the photo receiver will have all the coating already correct; you don't need to do anything, but if you're trying to make it a certain way, like you don't want it to go all the way, it could be tricky. But if you had it on manual, you could have it at a you can control how much light you're getting and how dark it is in the room.

Circuit 7

When the temperature in the room is greater than 75°, the blue LED will turn on; anything below 75 degrees, the green LED will turn on

Circuit 8

for(position = 0; position < 180; position += 10) and for (position = 180; position >= 0; position -= 10)

. These lines of code were originally

for(position = 0; position < 180; position += 20) and for (position = 180; position >= 0; position -= 20)

. It's from a speed of 20 to 10 that would make it go faster

Circuitnine.mp4

Circuit 9

Page updated

Google Sites

Report abuse