Final Assessment

The SolidWorks Final Assessment is based on the knowledge that has been gained from all other lessons/tutorials.

This assessment has revolve, fillets, and cut extrudes all in one project.

The project is Magneto's helmet.

Full display of the Final Assessment

Rotating GIF of the Final Assessment

Revolve Features

The revolve feature is used to create the cylinder shape, or the shell of the helmet. This feature was used two times.

First layer shell created with revolve feature

Second layer shell created with revolve feature

Mirror and Cut Extrude

The mirror feature was used to copy the sketch for the face to the other side. The cut extrude feature was used to cut the facial the sketch through the 1st revolved layer.

Face sketch being mirrored to the other side

Face sketch being cut extruded through the first layer

What happens after the mirror and cut extrude features happened

Bottom of the helmet was cut extruded slanted through the 1st and 2nd layers

Eye and mouth holes were sketched and cut extruded through the 1st and 2nd layers

The remaining of the second layer was cut extruded

Fillets and Finalizing

The sides of the faces were filleted to make the design more nicer. Also, a small little addition was made to finalize the project.

The sides of the small designs were filleted.

A small little symbol was sketched and cut extruded on the front of the project

Ready-To-Print Modifications

The project was modified again to make it printable and also made to clamp on to a desktop monitor pole.

A circle was sketched and base extruded to make a small, round clamp

The base extruded sketch was cut extruded to make it fit through the monitor pole