Embedded Files
Our testing facility is capable of the following
Our testing facility is capable of the following
- conducting tests on wall and floor (composite) panels (up to 12-13 ft length).
- conducting flexural testing on beams, floor joists, or purlins.
- conducting web crippling tests/any buckling mode on cold-formed steel sections.
- conducting axial compression test on columns up to 2 meters length with 3000 kN capacity.
- carrying out tension tests on any structural member.
- determining the mechanical properties of structural material (steel plates, steel rods, bolts, and sheathing material).
- determining the behavior of connections in constructional elements.
BENDING TEST ON STRUCTURAL (CONSTRUCTIONAL) COMPONENTS
BENDING TEST ON STRUCTURAL (CONSTRUCTIONAL) COMPONENTS
Beams, Wall panels and Floor panels (but not limited to)
Beams, Wall panels and Floor panels (but not limited to)
The bending test can be done for any structural component.
The maximum capacity can be up to 300 kN (30 Tonnes).
Maximum span up to 4 meters.
Bending test on Wall panels
Bending test on Wall panels
Maximum panel capacity up to 250 kN
Wall panel made of any Cold-formed steel members with any sheathing type (Cement board, plywood, fiber-cement board and gypsum board).
The sheathing material can significantly increase the strength of the member, for more details please see our publications or contact Dr.Madhavan.
Bending test on Floor Panels
Bending test on Floor Panels
Durability test (Artificial Rain) on CFRP strengthened beams
Durability test (Artificial Rain) on CFRP strengthened beams
Durability test can be done for any structural material.
Bending test on Steel Beams
Bending test on Steel Beams
The figure shows the Lateral Torsional Buckling of open cross section steel beams, this was done with unique test setup.
Axial Compression test on Steel Columns
Axial Compression test on Steel Columns
Maximum Axial Compression Capacity up to 3000 kN and 2 meter length
Bearing test on Puffed Wall Panels
Bearing test on Puffed Wall Panels
Bearing test was carried out for following parameters
- Bolt diameters
- Edge distance
- Panel sheet thickness
Bending test set-up for "Open-channel cross section" Channel beams
Bending test set-up for "Open-channel cross section" Channel beams
Testing Frame for large scale specimens (up to 4 meters)
Google Sites
Report abuse