The HSA Hydro Beam Pollution Control System
By HSA Hydro Beam Services SAS
Bogotá DC, Colombia
E-Mail: info@hsa-hydrobeam.com
The HSA Hydro Beam Pollution Control System
By HSA Hydro Beam Services SAS
Bogotá DC, Colombia
E-Mail: info@hsa-hydrobeam.com
Hydrogen Selective Activation Is
Best Thermal Efficiency and Clean Non-Scaled Boilers, Clean Air-X-Changers, Clean Air Aftercoolers, and Non-Scaled Firetubes!!
Hydro Beam Modules & Devices
Typical Scale Issues
Scale that forms on the waterside surface of pipes and equipment associated with water heating/cooling is a major problem that costs corporations and business owners millions of Bucks every year. Because scale acts as an insulator, it reduces heat transfer, so higher temperature is required to maintain effective heat flow. That additional fuel is wasted energy (See Table below) and, since not transferred, heat will add to the internal energy on the heat source side Surface, a sharp temperature increase will be observed on that wall side risking the equipment to thermal failure or deformation.
Scale, only one-half inch thick on the pipe Wall, will reduce the heat transfer capability by 60%, doubling the cost to heat a given amount of water to a particular temperature. Heavy scale deposits can also completely block water flow in sections of a thermal system, and even cause internal blockage of produced water lines, and accelerate corrosion. REMOVE SCALE BY TURNING IT INTO HIGHLY HYDRATED SLURRY AND FLUSH IT OUT OF YOUR SYSTEM IN A QUITE EASILY AND EFFORTLESS ECONOMICAL WAY: HSA WATER / CRUDE OIL CONDITIONING!!!
Typical examples of Scale build-up
In the upper one, scale build-up develops an excessively high Head Loss in the fluid severely reducing water flow in the pipeline.
In the lower one, scale build-up prevents heat removal from the machine jacket hot side to keep it cool, which drives to a dangerous overheating on its hot side forcing the machine to safety stop, otherwise risking it to severe damage.
The HSA Hydro Beam Pollution Control System Devices turn hard Scale deposits into highly cohesive, non-adhesive fluid SLURRY material which can be easily removed out of the equipment by simple flushing after a retention basin or HSA Hydro Concentrator device which prevents this material to go further into circuit lines.
Additional alternative to the above HSA Hydro Concentrator for fluid Scale removal is the HSA Twin Hydro Filter System, which can also be used to clarify and polish water streams after fluid Scale SLURRY removal.
HSA water treatment needs no chemicals to be added into the water and doesn't chemically change dissolved scale substances in the water. It just prevents and keeps insoluble matter from adhering as scale by tightly coating it with a strongly charged Hydrogen activated water molecules changing it into fine, flocculent SLURRY material that is flushed out from the system by periodic HSA Concentrator blow down or by HSA Twin filtration in closed loop circuits; And, since cohesive and non-adherent Floc are formed by the HSA water treatment, sedimentation will also readily proceed to yield crystal clear water in open loop circuits and treatment systems.
WITH AT A PLUS: NO CHEMICAL POLLUTANTS ADDED!!
Save Money while keeping an outstanding thermal performance and full cleanliness inside your water driven equipment, also get Crystal Clear Water without Chemicals, Through HSA Hydro Beam Pollution System Water Control and Conditioning.
Learn more at: www.hsa-hydrobeam.com
Consult your case at: info@hsa-hydrobeam.com
Registered Trade Mark - Pat Pending