Lay the plasterboard (εποξειδικα δαπεδα)
Step 3.1 :
Present the plate, change it concerning the ceiling and the past plate with the assistance of a plate lifter pedal and screw on the profiles each 25 cm.
Rehash the cycle along the wall.
Step 3.2: Cut the plasterboard plate
Measure the drywall top and base. With the assistance of a container shaper, follow the cut line and afterward pry along that line and separate the two cut parts.
Squeeze the plate cut with the fitting estimations into spot and screw it similarly as the past ones.
For the corner join, take the level and width estimations once more.
Get it done and place the plate similarly.
Instructions to lay the insulation outwardly
Support wall, which can be made of concrete, blocks or block.
Mortar is put on the wall for the placement of the plates, in the event that they are not supported with trimmings.
The expelled polystyrene (XPS) is stuck to the wall with the cement or with clasp.
Two layers of mortar are put on the insulation, reinforced with mesh that forestalls cracks and separations.
At long last, the mortar is made with the ideal finish, beforehand applying a layer of groundwork to further develop adhesion.
The most effective method to waterproof block facades
Clean the outer layer of the block facade. Eliminate all existing soil with a cleaner, descaler and a water fly.
Fix every one of the joints where the mortar has slackened, scratching to eliminate non-follower material and filling again with joint mortar.
Apply a first layer of waterproofing for porous material. You can do it with a brush or roller.
Before it dries and following the maker's recommendations, apply a second layer of waterproofing. It will be prepared to avoid water spills.
This is the way a channel is made around the walls
Dig around the edge of the house until you arrive at the foundation.
Fix the walls with waterproof mortar, if necessary, and apply bituminous waterproofing emulsion.
Place a high-thickness polyethylene protection and waste sheet that has a polyethylene gel textile mesh.
Fix it to the wall with nails and washers with the knobs confronting the wall.
Seal the joint with the wall with synthetic groups screwed and fixed with - clay.
Put geotextile mesh on the ground, add a layer of shingling and put the seepage pipe on top, which ought to end in a chest.
Load up with another layer of entombment, all enveloped by intertextile mesh. (πατητη τσιμεντοκονια)
Finish filling the land with endlessly rock and with the last finish, on the planet and grass or walkway or concrete piece.