The washing machine is located in the kitchen. Firstly, turn the water inlet tap on. The tap is found outside under the window. Remember to turn the tap off after as there is a significant leak in the fitting. Push the on/off button. From the left, the first button controls the amount of water, the second the duration of the wash, the third the number of rinses, and the fourth the duration of the spin cycle. You must run a spin cycle! To start from a later step, after turning on the washing machine, push the button where you want to start the cycle. For example, to do only a spin cycle, push the fourth button and then the start button. Pushing a button multiple times changes the setting. Powder goes in a pull out tray inside the washing machine. The amount of powder depends on the amount of water used. This information can be found next to the water level setting. Please set the water level only to what you need and use only one rinse cycle. If the machine beeps because of an error, it is most likely an unbalanced load. Simply open the lid, even the weight out and push start again.