Photo Documentation

I am screwing the 2x6's together for the floor joists.

I am toenailing the floor joists to the 5x5 beams.

I am screwing the plywood to the floor joists following a chalk line.

I am screwing the plywood to the floor joists.

I am screwing 2x4's together for the back wall.

I am securing the back wall to the floor.

I am measuring boards with a tape measure and marking them with a pencil.

I am cutting the boards with a miter saw.

I am cutting the boards with a miter saw.

I am screwing the double plate onto the top of the back wall.

I am attaching the 2x10 to the top of the front wall leaving 1 1/2 inches above the rafters.

I am using a chalk line to mark where the nailers should be put on.

I am attaching a nailer to the back wall.

I am measuring and marking a board before I cut it.

I am pulling the electrical wire through the ceiling to the utility boxes for the lights.

I am nailing the white j-channel to the top of the back wall.

I am using painted screws to attach the tin to the outside of the coop.

I am stapling the insulation to the 2x4 studs in the walls.

I am stapling the insulation to the 2x4 studs in the walls.

I am using the circular saw to trim off some of the tin.

I am using the miter saw to cut a board.

I am screwing the plywood sheeting on the ceiling to enclose the insulation.

I am screwing the plywood sheeting onto the ceiling to enclose the insulation following a chalkline.

I am screwing the plywood sheeting onto the walls to enclose the insulation and electrical wiring.

I am cutting the boards for the nesting boxes.

I am cutting the plywood for the nesting boxes.

I am assembling the nesting boxes.

I am using a tin snip to cut the corner trim.

I am using a large drill bit to drill a hole for the nine wire.

I am using painted screws to secure the white corner trim onto the outside of the chicken coop.