AutoCAD

Guide Plate without Dimensions.

Guide Plate finished

Spacer without Dimensions. Original construction

Spacer With Dimensions

Angle Spacer Without dim (before adding Dimension)

Finished Angle Spacer With Dimension

Base Plate w/o dim (before adding dimensions)

Finished Product of the Base Plate

T-Clip w/o dim before finished

Finished T-Clip with dimension

Channel Plate with only constuction lines.

Finished Channel Plate.

Slider Block w/o dim

Finished Slider Block with dimensions

Circular Spacer w/o dimensions

Finished Circular Spacer with dim.

Rocket Arm before construction (construction lines)

Finished product of Rocket Arm with dimensions

Adjustable support w/o dimesnions

Finished Adjustable Support with dimensions

V-Slide Plate with no dimensions

Finished V-Slide Plate with dimesnsions

Swivel Base w/o dimensions

Finished Swivel Base with dimensions

Sensor mount construction process

Finished dimensioned sensor mount

Flat hook construction lines

Finished Flat hook with dimensions

Journal bracket with no dim only construction lines

Finished Journal Bracket with dimension lines

Support Base construction lines

Finished support base with dimensions

Gasket Contruction lines ( just followed instructions for it) 

Fully dimensioned Gasket

Lines & Square Pattern contruction lines

Fully dimensioned Lines & Square Pattern 

The Interlacement Design. I Created this without construction lines. I made a 2x2 square and offset it .2 inside. I then copy and pasted the 2 squares and rotated them 45 degrees. I then created a 8 sided circumscribed polygon and offset it by .2 inches. I then created a circle so that it would touch the points on the outside polygon.

Fully dimensioned Interlacement Design

Construction lines for the Positioning Spacer

finished dimension lines for the Positioning Spacer

Construction lines for Indexing Base.

Finished dimension for the Indexing Base

Vent Cover construction lines

Vent Cover finished and dimensioned