Francisco Torres-Morales ePortfolio

CADD SoildWorks

Pressure Plate

Lesson 1, 2, and 3.

Seven-Piece Puzzle

Part 1

Part 2

Part 3

Part 4

Part 5

Part 6

Part 7

Assemble of the cube

Fillets(Process)

Fillets (Product)

The lines that separate the faces have fillets

The rest of the lines now have fillets

The mirror of the two

Revolve and Sweeps Features

Revolves and Sweeps (Product)

This is the mug without the handle

Pattern Features (Tutorial)

Pattern Features (Product)

Lofts (Process)

This shows the end of the hammer go down

Lofts (Product)

This is what the loft is going to follow

This is how it looked lofted

This is how it looked after a pivot

This is showing the shell cut

Mouse Gestures

The box it self

Made the part stick out

Extruded the rest of the parts

Used chanfer on most of the parts

Finish product

Advanced Design

This is the base of the hinge

This is the hole that the pin will go through

These are the inside of the hinge and the outside of the hinge

These are the parts of the pin that was used for the hinge.

This is the hinge fully done with the collision

SW Motion

This is with no modifications to it

This is with the motor increased

These are the motions with the change of the motion.

Practice 1.6

This is the finale result of the practice

This is the picture of the volume and the other properties of it

Practice 2.4

A still image of the part

This is the volume, mass, and other stats of the part made

This is the a full view of the practice part

Practice 3.4

What the part is based off of

Practice 4.16

A full rotation of the part

The part in isometric view

The stats of the part that I made

The digram for the part

Practice 5.13

Page updated

Google Sites

Report abuse