The Arduino is being programmed to flash the LED so fast that it can barley be seen that it is turning off.
The potentiometer would slow down when moving it to the right and moving it to the left will make.
This line of code is making the light change slow.
The light is changing faster then it did before.
The code is making the light bounce back and forth from each LED.
The manual pros are that it stays on at all time and with out light and will get stronger with out it
Cons it only gets scrounger by a bit and will never turn off if needed.
No changes were made to the code in this one.
This bit of code is making it so that it changes to manual Tune.
Pros for auto turns off when lights on and gets stronger by a lot when it has no light
Cons it is not going to be on when there is light and the light might get to strong if there is no light.
The code is making it spine faster
The original without any changes.