Assembling up the hardware consists of two main assembly:
The diagram below, along side the table show which component goes on each pad. Also attached is the video that demonstrate how to solder the SMD components, and tips and tricks for soldering the board in recommended order.
SolidWorks must be installed before beginning this tutorial. As of writing this, SolidWorks is only available on Windows Operating System. For a refresher of SolidWorks, refer to the SolidWorks tutorial.
Alongside the building the enclosure, there're a few files that's provide that's used during the assembly portion of the tutorial. They are in the mcad folder in the project's GitHub repository.
Part 1: Introduction
Part 2: The Top Side
Part 3: The Bottom Side
Part 4: The Front Side
Part 5: The Left and Right Side
Part 6: The Enclosure Assembly
Part 7: Assembling Assemblies
Part 8: The Back Side
Part 9: The Final Assembly
As the end of this module, the following should be completed:
The next step is to integrate the hardware with the website/software.