The following videos will walk you through the steps of using the Wazer Water Jet Cutter here at CraterWorks.
There are a few things you should know be for getting started
you need a .dfx file
it cost $0.50 a minute (rounded up the nearest dollar) to use the Wazer, this covers the cost of the abrasive and replacing the cutting beds as they wear out.
the cut bed is 12" x 18"
the Wazer can cut a variety of materials, as long as the material won't be damaged by being wet and is thin enough, then the Wazer will probably be able to cut it.
**Refer to interal WAM guidance on material type & thickness
you will need to monitor the Wazer as it cuts.
Making a mini pancake spatula on the wazer