GIF of the Pressure Plate

The first thing to do was to create the four planes based off of the right plane. 

Next a sketch was made to use the loft tool to connect the sketches. 

Then the loft tool was used to connect the first loft to the sketch made in plane 4.

The flex tool was used to change the loft and make it into an angle. 

Then I made an extrude cut to put my name in the sketch. 

This is the final product. 

First, there were three planes made from the orignal front plane. 

Next, the loft tool was used to connect the sketches used from the first and second plane. 

Then, using the loft tool, the sketch from plane three connected to the first loft. 

Using the flex tool, the object curved upward at a certain angle. 

Then I put my name in the side of the object. 

The finished final object.

This was the inital sketch of the object.

Then. using surface loft, the sketch extended down.

Using surface sweep,  the sketch took a 3-D form. 

Using surface sweep,  the sketch took a 3-D form. 

Then, using split line, it created a separate part within the sketch. 

Then, using split line, it created a separate part within the sketch. 

Using surface loft, the top part and the handle were able to connect.

Using surface loft, the bottom part and the handle were able to connect.

Using surface loft, the top part and the bottom part were able to connect.

Using Surface Knit, it made all three parts into the same body. 

Using surface fill, the open parts were filled in. 

Using Surface Knit, it made all three parts and the new surfaces into the same body. 

Using surface revolve, it made a cyclender go down. 

Surface trim was used to cut the excess parts of the object. 

Surface extrude was used to make the holes at the bottom. 

Body copy allowed the holes at the bottom to be copied and put at every 90 degrees. 

Then surface trim was used to cut the excess parts of the hole out of the object. 

Surface untrim was used to remove one of the holes at the bottom. 

The final finished object. 

A sketch was made and the sweep feature.

There was a circle sketch made that extruded from one side to the other. 

Using the pattern feature, the extuded circle is copied and moved across the sweep. 

Using the mirror feature, the entire body was mirrored. 

Final completed image. 

The sketch made was sweeped. 

A box sketch made was sweeped. 

The L sketch was sweeped. 

The box around the L is sweeped. 

The L and box sweep were mirrored across the right plane. 

The C and box sweep were mirrored across the front plane. 

A sketch was made and sweeped. 

An M was made and sweeped. 

The M was mirrored across the front plane. 

The Final completed project. 

This was an extrude for the cube.

Using Extrude a C was placed on the side of the cube. 

There was an extruded cut of an L on the top of the cube.

There was an extruded cut of a normal face.

There was an extruded cut of a surprised face on the side.

There was an extrude of a smiley face on the side. 

There was an extrude of a sad face on the bottom of the cube. 

The completed cube.