Development Board

ESP8266 NodeMCU CP2102 Board

₹350.00

Open-source, Interactive, Programmable, Low cost, Simple, Smart, WI-FI enabled

Arduino-like hardware IO

Integrated TR switch, balun, LNA, power amplifier, and matching network

Integrated PLL, regulators, DCXO, and power management units

Onboard USB to serial chip to easily program and upload codes from the Arduino IDE

Embeds logic level converter circuits

Has an onboard 3.3V regulator to ensure enough power to function as your go-to WiFi chip!

Easy access to the GPIO pins for easy prototyping

ESP-12E Processor

Easy to use breadboard friendly form factor

AES14D1

Arduino Uno R3 with Cable

₹590.00

Micro-controller : ATmega328.

Operating Voltage: 5V.

Input Voltage (recommended): 7-12V.

Digital I/O Pins: 14 (of which 6 provide PWM output).

Analog Input Pins: 6.

AES14D2

Lora E5 mini development board (original)

₹2,700.00

Stm32 software use to cod

AES14D3

Lora E5 development board original

₹3,700.00

AES14D4

ESP32 38Pin Development Board WiFi+Bluetooth Ultra-Low Power Consumption Dual Core

₹520.00

1. 2.4GHz Dual-Mode WiFi + Bluetooth Development Board, 38PIN

2. Ultra-Low power consumption works perfectly with the IDE

3. Support LWIP protocol, Freertos

4. Support Three Modes: AP, STA, and AP+STA

5. ESP 32 is safe, reliable, and scalable to a variety of applications

AES14D5

Raspberry Pi Pico

₹360.00

RP2040 microcontroller chip designed by Raspberry Pi

Dual-core Arm Cortex M0+ processor, the flexible clock running up to 133 MHz

264KB of SRAM, and 2MB of onboard Flash memory

26 × multi-function GPIO pins

2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels

Onboard temperature sensor

AES14D6

Nano CH340 Chip Board without USB cable compatible with Arduino (Soldered)

₹280.00

Operating Voltage (logic level): 5V

With Soldered Connector

8 analog inputs ports: A0 ~ A7

14 Digital input/output ports: TX, RX, D2 ~ D13

1 pair of TTL level serial transceiver ports RX / TX

Using Atmel Atmega328P-AU MCU

There is a bootloader installed in it

Standard 0.1” spacing DIP (breadboard friendly).

Manual reset switch.

AES14D7