In grad college at Iowa State University, I was involved in research work at the Wireless Systems Lab where we worked on next generation technology for improving communication. My project dealt with the pressing problem of developing efficient multi band circuits for RF communication devices, especially Consumer Electronics like Smart Phones. In this regard, I developed a simulation test bench on Keysight ADS, with the goal of optimizing the load pull sweeps for a concurrently operating dual band power amplifier. You can find a brief presentation of my work here.

Additionally, I took up coursework on Microwave Engineering

• ADS simulation and fabrication of a microwave transmitter system: Oscillator + Amplifier + Filter
• Introduction to RFIC architectures: PA, LNA, PLL, VCO, Mixer
• Modeling of basic Antenna structures using Ansys HFSS

These presented me with unique insight into the design challenges for communication circuits and helped gain invaluable debugging skills.

I believe that my industry exposure, choice of courses and the design/ analysis experience that comes with those, provides me with a combination of the most desired skill sets for an RF Engineer.

I would very much like to discuss opportunities, right now. To schedule an interview, please call me at +1 515 735 6345. There is no bad time to reach me, but if I happen to miss your call, please do leave a voice message, and I will return your call.

Thank you for taking the time to getting to know me. I look forward to talking with you.