Quick answer: This glossary gives short definitions of common fan and ventilation terms, from ACH and CFM to static pressure and IP ratings. Use the links for deeper guides.
ACH (air changes per hour). The number of times per hour that a space's air volume is replaced with outdoor air.
Air circulator. A fan that moves air within a space without bringing in outdoor air.
Air delivery. The volume of air a fan moves, often listed in m³/min or CFM.
Air throw. The distance a fan's air stream travels before it slows too much to be useful.
Air velocity. The speed of air at a point, in m/s or ft/min.
Ambient temperature. The air temperature around the equipment.
Axial flow fan. A fan that moves air in a line parallel to its shaft.
Ball bearing. A part that lets the motor shaft turn with low friction.
BLDC motor. A brushless direct current motor with permanent magnets and electronic switching.
CFM. Cubic feet per minute, a unit of airflow volume.
CMM. Cubic metres per minute.
Centrifugal fan. A fan that throws air outward from a spinning wheel, often used for higher pressure.
Duty rating. The maker's description of the work a fan is built to do, such as heavy or commercial duty.
Exhaust fan. A fan that removes air from a space.
Free air delivery. Airflow with no system resistance.
Guard. A cage that stops contact with the blades.
Impeller. The rotating part with blades that moves air.
Induction motor. An AC motor where the rotor current comes from induction, with no magnets in a standard design.
Input power. The electrical power a fan draws, in watts.
IP rating. A code showing protection against dust and water.
kWh. Kilowatt hour, the unit of electrical energy that bills use.
Oscillation. Side to side sweep of a fan head.
Recirculation. Moving indoor air around without exchanging it with outdoor air.
RPM. Revolutions per minute.
Static pressure. Resistance to airflow in a system, often in mm WG or Pa.
Stratification. Layering of warm air at the top of a space and cooler air below.
Thermal overload protection. A device that cuts power when a motor overheats.
Tilt adjustment. A control that angles the fan head up or down.
TEFC. Totally enclosed fan cooled, a motor enclosure type.
Ventilation. Replacing indoor air with outdoor air.
For the ideas behind these terms, read Industrial Airflow Basics and Understanding CFM and Airflow. For quick answers, visit the FAQ Hub.
Need a definition we missed? Tell us through the Contact and Enquiries page.