LUBA 2/3 Assembly Instructions

Luba 2 Front FENDER installation

Luba 3 Front FENDER installation

1. Remove original fender, two screws from top

2. Keep screws with the original fenders so you don't lose them

3. Place the inner edge of the fender against the body

4. Press the fender on until it snaps down, only press above the clips.

Luba 2/3 Rear fenders installation

Luba 2/3 wing installation

1. Bottom out the white part of the bumper

2. Slide on the front wing from the side

3. Check that the Luba beeps when you press the bumper

Common mistake is to slide it on the white part only and that results in poor fitment and disabling the bumper sensor. 

Luba 2 f1 fenders installation

1. Clean the surface for the rear wing/fender with IPA

2. Test mount to get a feel for the location before removing tape backing

3. Remove tape backing , line up and install and push down to get the tape to stick properly.

4. Front fender snaps on from above.