Starting a Print
Starting a print on a Ditto Pro 3D Printer requires several steps to ensure a successful outcome.
Once the slicing is complete, the G-code file is saved to an SD card, which is then inserted into the printer's SD card slot. Apply masking tape and hair setting spray on the glass surface before printing to ensure the 3D print can stick on the surface properly.
The user can then select the file from the printer's interface. Finally, the print can be initiated, and the printer will begin to create the object layer by layer, building up the model until it is complete.
Please check the video below as a tutorial. Please make sure you are familiar with the procedure before you continue. You should always ask a Sandbox staff if you are unfamiliar with the it.
Preparing The Print Surface for the Ditto™Pro.mp4How to prepare the print surface
How to Start a Print on the Ditto™Pro.mp4How to start a print on Ditto Pro
How to remove a model off the print surface.mp4How to remove the model off the print surface
Video Courtesy from TInkerine.