Embedded Files
Inventory
Inventory
Day 1
Day 1
The lower bumper beam was installed and this is the final look.
The lower beam is held in place with 3 clamps on each side with nuts nd bolts.
This is the Upper Beam that was installed to the front of the car.
The bottom portion of the beam is held to the car with a clamp that was tightened using nuts and bolts.
The upper portion of the beam was held in place with nuts and bolts that went in to the frame of the car.
Day 2
Day 2
This is the trail arm on the passenger side.
This is how the trail arms go into the Frame.
This is the trail arm on the driver side.
This is how the thru rod goes into the lower trail arm.
Day 3-4
Day 3-4
This is how the shock attachs to the lower arm using a locknut and two spacers.
This is how the shock sits when it is fully attached.
This is the top of the shock attached tot he frame of the car using a bolt, spacer, and nut.
After the shocks were put on the spindles were attached to the upper and lower trailing arm joints using locknuts.
Page updated
Report abuse