A 3D printable humanoid robot using low cost electronics, actuators and sensors.
Uses My Robot Lab software.
Spherebot is a variant of the Eggbot, which can draw on a spherical object like eggs, ping-pong balls, xmas baubles, etc.. The Spherbot uses an Arduino to control a servo and a couple of Stepper Motor Drivers.
The Cyclone a 3D Printable PCB milling machine developed in the same spirit as RapRap 3D printers. The hardware design is open and the community has contributed to its continuing development. Some useful resourses are the RepRap wiki and Thingiverse depot.
HexTronik HTX90: (typ. £3.25 @ sparksid_rc)
A small (9g) servo motor with 1.6kg of force. Typical specs can be seen on the HobbyKing website.
Specs:
17HS19-1684S: (typ. £12.50 @ Think3DPrint3D)
Popular bipolar (2 windings) motor with molex connector and plenty of torque for 3D printing.
Specs:
Allegro A4988: (typ. £3.50 @ EllieShang)
DMOS Microstepping Driver with Translator and Overcurrent Protection, see datasheet.
Typically supplied on a carrier board with 0.1" headers.
Specs: