Gas Log set pilot lighting example

WARNING! ALWAYS follow the manufacturers instructions for your specific make and model of fireplace!

Information provided here is for example only, Gas-Xpress, llc assumes no liability for your use of this information.

A. This appliance has a pilot, which must be lit by hand. When lighting the pilot, follow these instructions exactly.

B. Before lighting smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the

floor.

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

PILOT LIGHTING PROCEDURE

1. Turn the gas control knob to the off position (it will be necessary to depress the knob slightly at the pilot position). Allow five minutes for any gas in the

combustion chamber to escape (LP gas, which is heavier than air, may require forced ventilation).

2. Turn the gas control knob to the pilot position.

3. Push in on the gas control knob and light the pilot immediately. Hold the knob down for one full minute after lighting the pilot.

4. When the gas control knob is released, the pilot flame should continue to burn (if the pilot goes out, repeat the above steps).

5. Rotate the gas control knob from pilot to on position (full counterclockwise position) to supply full flow of gas to main burner.

6. You can adjust the flame height by the control knob, if you turn it back towards the pilot position you will decrease the gas flow, in turn you will decrease the flame height.

FOR YOUR SAFETY

"What to do if you smell gas"

* Do not try to light any appliance.

* Do not touch any electrical switch; do not use any phone in your building.

* Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

* If you cannot reach your gas supplier, call the fire department.

C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it. Call

Gas-Xpress, llc. Forced or attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under water. Immediately call Gas-Xpress, llc to inspect the appliance and to replace any part of the control system and any gas control which has been under water.