Ensure your design meets the following requirements:

• All objects are dropped to the base work plane. All objects should be touching the bottom. If they are hovering they will not stick to the base plate.

• Make sure you do not have overhanging pieces that extend more than 45' from the previous layer.

• Check to make sure your measurements are correct and the units you are using are consistent with the processing stage in the machine setup.

• Make sure STL file is flat on baseplate

• Set infill to minium accptable percentage

• Determine if your print will need a raft

• Check speed and feed rate

• Check fillament type and temperature settings

• Connect using correct COMM number

• Make sure the bed is clear and flat

• Complete a zeroing test to make sure your print will evenly adhere to the base plate.

• Check filament spool is not tangled and connected through the guide tube to the extruder.

• Make sure extruder is clean and clear

If you made something that you would like to print then please make the file “public” and share the link with me.