CLAMPER CIRCUITS

Simulation

1) Simulate the operation of positive and negative clamper circuits using

    diodes, capacitors, and resistors.

2) Extract key parameters:

•    Peak output voltage.

•    Clamping voltage levels.

3) Analyze the effect of different input signal amplitudes and frequencies on  the

     clamping behavior.

4) Compare simulated waveforms with theoretical predictions and datasheet

     values of diodes and capacitors.

Procedure

1) Open LT Spice and create a new schematic.

2) Select the required components:

1. • Voltage source, diode, resistor, and capacitor.

   • Place the components on the schematic workspace.

3) Construct the clamper circuits:

1. • For the positive clamper:

     • Connect the diode (D1) with its cathode to the load and anode to the capacitor-resistor junction.

     • Connect the capacitor (C1) in series with the voltage source, followed by the load resistor (R1).

   • For the negative clamper:

     • Reverse the diode's orientation and adjust the circuit connections similarly.

4) Set the voltage source:

1. • Use a sine wave input with 230v  peak amplitude and 50Hz frequency.

5) Add simulation commands:

1. • For clamping analysis, use a transient simulation:
     .trans 0 100ms

6) Run the simulation to observe:

1. • Input waveform (V{in})​.

   • Output waveforms (V{out})​ for positive and negative clampers.

7) Measure key parameters:

1. • Measure clamped voltage levels and ripple voltages across the load R1.

   • Record observations for different frequencies of the input signal (e.g., 50Hz, 100Hz, 500Hz).

Circuit Diagram

Positive clamper

Negative clamper

Nature Of the graph

Positive clamper

Negative clamper

Result

Positive Clamper:

• Successfully clamped the negative peaks of the input waveform at the diode's  forward voltage level.

• The capacitor's value affected the clamping stability.

Negative Clamper:

• Successfully clamped the positive peaks of the input waveform at the diode's forward voltage level.

• Similar capacitor and load effects were observed.

The simulated output waveforms closely matched theoretical predictions.

Conclusion

The simulation verified the functionality of positive and negative clampers:

• Positive clampers shift the waveform upward, while negative clampers shift it downward, effectively altering the reference voltage level.

• The choice of capacitor and load resistance significantly impacts clamping performance and stability.

• The results align well with theoretical expectations, demonstrating the ability of clamper circuits to manipulate AC waveforms efficiently.