BUILDING INTERIOR

1. WAINSCOT: ALL HIGH TRAFFIC AREAS TO HAVE 4"-0" DIAMOND PLATE

2. CART STORAGE AREA: FLOOR MOUNTED CRASH BARS / WALL PROTECTION

3. HVAC UNIT NOT PLACED DIRECTLY INFRONT OF ELEVATORS: NO AIR HANDLERS OR OTHER EQUIPMENT TO BE LOCATED IN LOADING LOBBY. PREFER HALLWAY

4. SUPERGRAPHICS: CART AREA AND ELEVATOR DOORS TO RECEIVE BRANDING. PREP WALL ACCORDINGLY. CONTACT "AMGRAPH"

5. UPGRADED LIGHTING FIXTURES: REFER TO LIGHTING SECTION FOR SELECTION

6. SECURITY CAMERAS: COORDINATE CAMERA AND SECURITY LOCATIONS AT ALL LOADING AREAS AND ALL ENTRANCES TO BUILDING

7. STANLEY SLIDE "DURA GLIDE": CONFIRM DOOR R.O. AND ALL OTHER REQUIREMENTS, DOORS SHOULD LOCATED FOR EASE OF LOADING AND ELEVATOR ACCESS.

1. RECESSED EXTINGUISHER

2. HVAC UNITS: NOT TO BE MOUNTED ABOVE CUSTOMER UNIT DRIP PAN PROPERLY DRAINED, GRAVITY CONDENSATE LINES NOT PENETRATE STORAGE UNITS, ACCESS PANEL TO BE LOCATED FOR EASE OF MAINTENANCE, 110 AC OUTLETS DISCREETLY MOUNTED 8"-0" A.F.F, T-STAT MOUNTED 8"-0" A.F.F, T-STAT LOCKED & PROTECTED

3. LIGHTING: CENTERED ON UNIT DOORS (10"-0" O.C.), REFER TO LIGHTING SECTION

4. CONVENIENCE OUTLETS: MOUNTED ABOVE 8' A.F.Fa DISCREETLY PLACED. IF MOUNTED BELOW 8'-0"- PROPERLY SECURED IN LOCK BOX

5. UNIT NUMBERS / PLAQUES: CONTACT AMGRAPH

6. HARDWARE

7. FIRE PROTECTION

8. FLOORS: ALL HALLWAYS TO RECEIVE NOX-CRETE CURE AND SEAL 100E 2 PART DENSIFIER OR WAX, INTERIOR UNITS WILL NOT BE FINISHED

9. DUCTWORK: ALIGNED ON EDGE OF HALLWAY, COORDINATE WITH LIGHTING HEIGHT AND FIRE PROTECTION

FINISH: NOX-CRETE CURE & SEAL 100E 2 PART SYSTEM

by Nox-Crete shall be applied to the entire slab in accordance with specification immediately following the concrete slab pour.  The slab shall be cleaned and free of contaminants.  Prior to the installation of the door and hall systems, contractor shall clean the entire slab with a floor scrubber.  At the conclusion of construction and final clean, the contractor shall apply 2 coat of Cure & Seal 100E by Nox-Crete to all hallways.  Doors shall be in the open position and a clean tape line shall be applied at the entrance of all units to ensure a uniform finish.