Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Finalize design
Determine which methods are going to be used and how
Accomplishments from Previous Week
Wire brush at low rpm removed resin very well after heating
Air gun was able to remove resin in the tray holes
Heat, mechanical system (rotating wire brush), and compressed air were necessary to sufficiently clean the trays
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Purchase and begin building prototype
Determine the exact components needed for design
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Consider using a heat gun with higher velocity
Conveyor belt to move trays through the system of components (heat, brush, air blow)
Cheaper than using linear rails
Use rotary motion for scraping (wire brush)
Halogen bulbs for heating
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Be concise when explaining the project during the presentation
Focus on the design
Explain risk reductions and component analysis
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
N/A
Risks and Areas of Concern
Resources or Information Required but not Available
Schedule
Describe upcoming milestone
Update Gantt chart.
Budget (list amount spent and amount remaining)
Progress on Report and Webpage